OHAUS T24PE Manual De Instrucciones página 5

RS232 Interface
SETUP
Upon installation, the print sub-menu will be visible.
Print
Reset
Baud Rate:
Parity:
Stop Bit
Handshake:
Stable Only
Auto Print
Content
Layout Format
End Print
Note: For more detailed information, see section 3.8 in the T24PE instruction manual.
OPERATION
Output
With the interface installed the scale will operate in one of the following two ways:

Auto Print = off, Stable = on or off
Pressing PRINT will send the display data. If Stable is set to On, the balance will wait for a
stable reading before sending data.

Auto Print = not off, Stable = on or off
The scale will automatically send data based on the settings in the Menu. If Stable is set to On,
only stable will be sent.
Data sent is in standard ASCII format terminated with a [CRLF] (carriage return-line feed).
[weight]
[space]
[unit]
[space]
[stability]
[space]
[G/N]
[Term. Char(s)]
No, Yes
300, 600, 1200, 2400, 4800, 9600, 19200
7 Even, 7 Odd, 7 None, 8 None
1 or 2
Off, XON/XOFF
Off, On
Off
On Stable (-> Load, Load and Zero),
Interval (-> 1...3600),
Continuous
Result (->Off, On, NUM)
Gross (->Off, On)
Net (->Off, On)
Tare (->Off, On)
Unit (->Off, On)
Mode (->Off, On)
Info (->Off, On)
(->Multiple, Single) Feed (->Line Feed, 4 Line Feed, Form Feed)
Exit PRINT menu
11 characters
1 character
5 characters max (left justified)
1 character
1 character
1 character
1 character
"?" when unstable, blank when stable
EN-3