Installing The Faucet - Conglom QK82R Manual Del Usuario

Installation (continued)

INSTALLING THE FAUCET

- Connect the sprayer head (1) to the sprayer
head connector (2).
- Remove the gasket (3), metal washer (4), and
retaining nut (5) from the faucet.
- Install the faucet through the hole in
the sink (A).
- From underneath, secure the faucet to the
sink with the gasket (3), metal washer (4), and
retaining nut (5).
- Tighten the retaining nut (5) by hand until it is
snug . Use a wrench to tighten it down . Gently
tighten the two screws on the retaining nut .
Do not overtighten .
- Hand-tighten the hose (6) to the faucet outlet
(7). Tighten the fittings using two wrenches.
Hold the faucet outlet (7) steady with a
wrench while turning the hose fitting with
another wrench until it is snug .
NOTE: Failing to use two wrenches can damage the
faucet and void the warranty. Do not overtighten.
- Push the sprayer head (1) into the faucet
neck. Install the counterweight (8) a couple
of inches from the bottom of the hose on the
side closest to the sprayer head (1). There
should be no slack in the hose and it should
retract freely .
- Connect the water supply lines (not supplied)
to the faucet .
- This faucet is equipped with standard
1/2" NPS male thread connectors that are
compatible with standard 1/2" FIP water
supply lines .
Please contact cs@conglomkb .com or 1-877-333-0098 for further assistance .
Sprayer Head
Connector (2)
Sprayer
Head (1)
Gasket (3)
Retaining Nut (5)
Counterweight (8)
Faucet outlet
Hose
11
Faucet body
Sink (A)
Metal Washer (4)
Screws
Faucet Outlet (7)
Hose (6)
Fig . 9
Water Connectors
1/2" NPS thread
1/2" FIP water supply
line compatible
(not supplied)
Fig . 10
CONGLOMKB .COM