Conglom QK82R Manual Del Usuario página 7

Installation (continued)
TESTING THE FIT OF THE SINK
- Place the sink (A) underneath the cut-out
in the counter to test its fit. Ensure that the
reveal is equal on all four sides when viewed
from above . Make adjustments to the cut-out
if necessary .
- When you are satisfied with the location of
the sink (A), mark the location of the edge
of the counter cut-out on top of the sink
and all around the sink flange underneath
the counter .
- Set the sink aside and proceed with the rest
of the installation .
DRILLING THE HOLES FOR THE
UNDERMOUNT CLIPS
- On the underside of the counter, mark the
location of the ten holes for the undermount
clips (F). These holes should be equally
spaced around the sink flange outline as
shown below . They should be set back from
the sink flange outline by 5/8 in (15.8 mm).
- Using an electric drill with a 27/64 in .
(10.6mm) drill bit, drill each hole so that it is
9/16 in. (14 mm) deep. Use a drill bit depth
stop to ensure you do not drill through the
counter top .
Please contact cs@conglomkb .com or 1-877-333-0098 for further assistance .
A
CAUTION: Always wear safety
goggles and gloves in order to avoid
personal injury .
5/8 in
15.8 mm
Undermount clip hole locations
(Underside of counter)
7
Fig . 2
Sink flange outline
Fig . 3
CONGLOMKB .COM