Installing The Strainers - Conglom QK82R Manual Del Usuario

Installation (continued)

INSTALLING THE STRAINERS

NOTE: If you are installing a garbage disposer (not
supplied), do not install the strainers.
- Apply plumbing putty or silicone sealant
(not included) to the top side of one of the
drain openings .
- Insert the strainer body (15) into the
drain opening and press it down until it is
evenly seated .
- Assemble the rubber gasket (16), fiber washer
(17) and strainer locknut (18) onto the strainer
body (15) from underneath the sink. Hand
tighten the strainer locknut (18) until it is snug.
Do not overtighten .
- Insert the plastic flange (19) into the flange-end
of the tailpipe (20) (not supplied) then secure
the tailpipe to the strainer body using the
connecting nut (21). Tighten the connecting nut
(21) until it is snug. Do not overtighten.
- Remove excess sealant from around the
drain opening .
- Repeat to install second strainer .
DRAINAGE
- The tailpipe (not supplied) previously installed to the drain can now be connected to your household
plumbing. In some cases, your household plumbing will have to be modified to ensure proper drainage. If so,
please consult a licensed plumber to complete needed modifications
SUPPLY LINES (NOT INCLUDED)
- Connect the supply lines to your home's water supply as per
manufacturer's instructions .
- Open the hot and cold water supply valves and check to make sure
they have been installed to appropriate inlet ports . Check for leaks . Run
hot and cold water uninterrupted for about one minute to remove any
residue from the lines .
Please contact cs@conglomkb .com or 1-877-333-0098 for further assistance .
Sink (A)
Fig . 13
.
13
Strainer Basket (22)
Strainer Body (15)
Sealant
Rubber Gasket (16)
Fiber Washer (17)
Strainer Locknut (18)
Plastic Flange (19)
Tailpipe (20)
(not supplied)
Connecting Nut (21)
CONGLOMKB .COM