Installing The Grids; Maintenance; Cartridge Replacement - Conglom QK82R Manual Del Usuario

Installation (continued)
INSTALLING THE BOTTOM GRIDS
- Ensure that the strainer baskets (C) are
already in the sink (A) before placing the
bottom grids (B).
- The bottom grids (B) must be positioned with
the rubber supports down . Tilt the grids up so
it is at an angle, slide it into the sink (A), and
place it so that it is sitting flat on the bottom
of the sink .

Maintenance

CARTRIDGE REPLACEMENT

- Turn off the water supply to the faucet .
- Unscrew the handle lever (23). Loosen the set
screw (25) with the hex key and remove the
handle body (30).
- Gently unscrew the decorative cap (29) and
retaining nut (28).
- Pull the cartridge (27) out of the faucet
body (26) and replace it with a new
ceramic cartridge . Ensure new cartridge
is seated properly with the locating pins in
appropriate place .
- Secure the cartridge in place using the
retaining nut (28).
- Gently tighten the retaining nut (28) using a
wrench . Do not overtighten .
- Reinstall the decorative cap (29). Slide the
handle body (30) back onto the cartridge and
make sure it rotates freely . Secure the handle
body (30) in place using the set screw (25)
and reinstall the handle lever (23).
- Turn the water supply to the faucet back on .
- Operate the faucet to make sure everything
works correctly and check for leaks .
QK82R
NOTE: Faucet and soap dispenser not shown for clarity.
A
Faucet Body (26)
Cartridge (27)
Retaining Nut (28)
14
B
Handle Lever (23)
O-Ring (24)
Set screw (25)
Decorative Cap (29)
Handle Body (30)