Securing The Radiator Controller; Standard Time Program (Factory Setting); Setting The Position Of The Display - Honeywell TheraPro HR90 Guia Del Usuario

THERAPRO HR90
Mounting the radiator controller
3
1. Ensure that the slide on the radiator controller is in
the open position.
2. Put the radiator controller onto the valve baseplate
so that the indentation latches in and is no longer
visible.
3. Lock the radiator controller in the end position. To
do so, push the slide towards lock.
After approx. 1 minute CYCL (self-test) is displayed.
Afterwards the radiator controller changes to auto-
matic mode.
NOTE: The radiator controller only operates if it is
locked correctly in the end position.
FINISHED! – After mounting, the radiator controller
operates immediately in the factory setting (standard time
program), see Section 5.

Securing the radiator controller

NOTE: The radiator controller and the batteries can
be secured against removal by using the sup-
plied screws.

Setting the position of the display

In order to improve the legibility the display of the radiator
controller can be tilted to different positions (10°, 20°, 30°,
40°).
33-00084EFS—02
1
2
M35635
°
M35636
M35637
The angle of 40° can be fixed with the supplied display
support.
1
Mounting
1. Lift the display and set it to the desired angle.
2. If desired, tilt the display by 40° and slide the display
support from above between the display and the
housing until it latches in.
Unmounting
Press the display support in at the back and remove it
upwards.
5. OPERATION
Standard time program (factory
setting)
In automatic mode, the radiator controller automatically
controls the room temperature in accordance with the
stored time program.
Week program 1: At home all day
Factory preset time program is set for each day of the
week Mo – Su (1 – 7):
12am 6am
68°F
LOWERING/
SAVING
61°F
SETPOINT1
Set-
point Time
1 6:00 am – 10:00 pm
2 10:00 pm – 6:00 am
• Two further week programs are stored in the radiator
controller. Further information is available in Section 9.
• You can also adapt one of the stored week programs to
your individual requirements, see Section 8.
4
2
12pm 6pm
HEATING
Temperature
68 °F (Comfort temperature 1)
61 °F (Setback temperature)
M35638
12am
SETPOINT2
M35641