Batter Transport; Service And Repair; Battery Disposal; Machine Disposal - RIDGID TC-40 Manual Del Usuario

TC-40 Cutter
Long term storage in temperatures
NOTICE
above 104°F (40°C) can permanently reduce
the capacity of the battery pack.
Battery Transport
The battery is tested according to UN docu-
ment ST/SG/AC.10/11/Rev/3 Part III, subsec-
tion 38.3. It has effective protection against in-
ternal overpressure and short circuiting as
well as devices for the prevention of violent
rupture and dangerous reverse current flow.
The lithium-equivalent content in the battery is
below applicable limit values. Therefore, the
battery is not subject to national or interna-
tional regulations pertaining to dangerous
mediums, neither as an individual compo-
nent nor when inserted into a machine.
However, the regulations governing danger-
ous goods may be relevant when transporting
several batteries. In this case, it may be nec-
essary to comply with special conditions (e.g.,
concerning the packaging).

Service and Repair

WARNING
Improper service or repair can make
equipment unsafe to operate.
The "Maintenance Instructions" will take care
of most of the service needs of this ma-
chine. Any problems not addressed by this
section should only be handled by an author-
ized RIDGID service technician.
Tool should be taken to a RIDGID Indepen-
dent Authorized Service Center or returned to
the factory.
For information on your nearest RIDGID Inde-
pendent Service Center or any service or re-
pair questions:
• Contact your local RIDGID distributor.
• Visit www.RIDGID.com or
www.RIDGID.eu to find your local Ridge
Tool contact point.
• Contact Ridge Tool Technical Services
Department at rtctechservices@emer-
son.com, or in the U.S. and Canada call
(800) 519-3456
10

Battery Disposal

the lithium-ion battery packs once they have
reached the end of their useful life.
RBRC™, RIDGID
ers have developed programs in the USA
and Canada to collect and recycle recharge-
able batteries. Normal and rechargeable bat-
teries contain materials that should not be
directly disposed of in nature, and contain
valuable materials that can be recycled. Help
to protect the environment and conserve nat-
ural resources by returning your used batter-
ies to your local retailer or an authorized
RIDGID service center for recycling. Your
local recycling center can also provide you
with additional drop-off locations.
RBRC™ is a registered trademark of the Re-
chargeable Battery Recycling Corporation.
For more information, go to www.rbrc.org.
For EC countries: Defective or used battery
packs/batteries must be recycled according
to the guideline 2006/66/EEC.

Machine Disposal

Parts of the TC-40 Cutter contain valuable
materials and can be recycled. There are
companies that specialize in recycling that
may be found locally. Dispose of the com-
ponents in compliance with all applicable reg-
ulations. Contact your local waste manage-
ment authority for more information.
For EC Countries: Do not dis-
pose of electrical equipment with
household waste!
According to the European Guide-
line 2002/96/EC for Waste Elec-
trical and Electronic Equipment and its imple-
mentation into national legislation, electrical
equipment that is no longer usable must be
collected separately and disposed of in an
environmentally correct manner.
Ridge Tool Company
The RBRC™ (Rechargeable
Battery Recycling Corporation)
Seal on the battery packs
means that RIDGID has al-
ready paid the cost of recycling
® , and other battery suppli-