Canopy Assembly; Blade Assembly - Craftmade AT52 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

7. Canopy Assembly.

Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of the
hanging bracket. Partially loosen the other screw.
Lift canopy to hanging bracket. Place rounded part
of slotted hole in canopy over loosened screw in
hanging bracket and push up. Twist canopy to
lock. Re-insert screw that was removed and then
tighten both screws securely.
Slide canopy cover up to canopy, aligning rounded
part of slotted holes in canopy cover with screw
heads in bottom of canopy. Turn canopy cover to
the right (clockwise) until it stops.

8. Blade Assembly.

Time Saver: Washers for blade screws can be set
on each blade screw prior to installing blades.
Locate 15 blade attachment screws and washers
in hardware pack. Hold blade arm up to blade
and align holes. Insert 3 blade attachment
screws (along with washers) with fingers first
and then tighten screws securely with a Phillips
screwdriver. Repeat for the remaining blades.
Remove blade arm screws and lock washers
from underside of motor. If plastic motor locks
are installed with blade arm screws, discard
plastic motor locks (save blade arm screws and
lock washers to secure blade arms). Align blade
arm holes with motor screw holes and attach
blade arm with lock washers and blade arm
screws. [Note: Use slot located on switch
housing plate for easy access to motor screw
holes with screwdriver.] Before securing screws
permanently, repeat with remaining blade arms.
Securely tighten all screws.
Important: Tighten blade arm screws twice a
year.
canopy
screw
plastic
motor
lock
lock washers
page 6
hanging bracket
screw
canopy cover
motor housing
blade attachment
screws and washers
blade arm
blade arm screws
blade

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido