Axxess AFSI-02 Instrucciones De Instalación página 3

The following wires are for the aftermarket radios that have navigation built in.
• Connect the Light Green wire to the parking brake wire of the aftermarket
navigation radio.
• Connect the Blue/Pink wire to the VSS or speed sense wire of the aftermarket
navigation radio.
• Connect the Green/Purple wire to the reverse wire of the aftermarket
navigation radio.
From the 22-pin harness
The DIN plug is not used in this application.
From the 24-pin harness
• Connect the Black wire to the ground wire of the aftermarket radio.
• Connect the Yellow wire to the constant wire of the aftermarket radio.
• Connect the Blue wire to the antenna turn-on of the aftermarket radio.
• Disregard the Blue/White wire. This wire is not used in this application.
• Connect the Violet wire to the right rear positive wire of the aftermarket radio.
AFSI-02
Installing the Interface
• Connect the Violet/Black wire to the right rear negative wire of the
• Connect the Green wire to the left rear positive wire of the aftermarket radio.
• Connect the Green/Black wire to the left rear negative wire of the
From the Ford 16-pin harness
• Connect the RSE/SYNC/SAT RCA's to the AUX in on the aftermarket radio.
• Disregard the labeling on the RCA. This interface only retains SYNC.
Installing the AFSI-02
1. With all the connections completed, plug the 22 and 16-pin harnesses
2. Plug the 24, and 16-pin Ford harness into the vehicle side harness, and plug the
3. Reconnect the negative battery terminal.
4. Initialize the interface by cycling the key by turning the ignition on for 30
3
aftermarket radio.
aftermarket radio.
into the AFSI-02
aftermarket radio harness into the aftermarket radio.
seconds then back off, and then back on again to test the radio.