Cub Cadet RZT S Serie Manual Del Operador página 10

3. Place the flat washer and belleville washer over the steering
wheel and secure with the hex screw. See Figure 3-3.
Hex Screw
Belleville Washer
Steering Wheel
Column
4. Place the steering wheel cover over the center of the steering
wheel and push downward until it "clicks" into place.
Install Operator's Seat
To install the seat proceed as follows:
NOTE: The seat is shipped with the seat switch and seat
pan attached. A second person may be needed to hold the
seat.
1. Cut any straps securing the seat assembly to the tractor.
Remove any packing material.
NOTE: Be careful not to cut the wiring harness connecting
the seat and the seat switch in the bottom of the seat.
2. Remove the two shoulder screws and flange lock nuts in
the seat pan as shown in Figure 3-4.
Flange Lock Nuts
10 S 3— A
ection SSembly
Steering Wheel Cover
Steering Wheel
Figure 3-3
Shoulder Screws
Figure 3-4
& S -U
et p
3. Rotate the seat into position and secure the seat into place
with the previously removed shoulder screws and flange
lock nuts. Be careful not to crimp or damage the wire
harness while installing the seat. See Figure 3-5.
Flange Lock Nuts
Figure 3-5
NOTE: Be sure to push the excess wire from the wire
harness into the seat box hole before continuing.
Lower Deck Discharge Chute Deflector
WARNING!
Never operate the mower deck
without the chute deflector installed and in the
down position.
NOTE: For models with a 46", 50" and 54" Deck skip ahead
to step 6.
1. Remove the keys that are attached with a zip tie to the
chute bracket.
2. Remove the flange lock nut and hex screw from the deck.
3. Place the chute deflector on the deck, be sure to insert the
tabs on the chute deflector into the holes on the deck. See
Figure 3-6.
5
4
Figure 3-6
Shoulder Screws
5
4
3