Cub Cadet RZT S Serie Manual Del Operador página 15

Park Brake/
Cruise Control Lock Pedal
The park brake/cruise control lock pedal is
located at the base of the steering column.
It is used to engage the park brake when the
tractor is at rest. Engaging the lever while the
tractor is in motion allows the tractor to remain
at a constant ground speed without applying
pressure to the forward drive pedal. Refer to the
Operation section of this manual for detailed
instructions regarding the parking brake as well
as the cruise control feature.
NOTE: Cruise control can NOT be engaged
at the tractor's fastest ground speed. If the
operator should attempt to do so, the tractor will
automatically decelerate to the fastest optimal
mowing ground speed
NOTE: The park brake must be set if the operator
leaves the seat with the engine running or the
engine will automatically shut off.
WARNING!
Never leave a running
machine unattended. Always disengage PTO, set
parking brake, stop engine and remove key to
prevent unintended starting.
Hour Meter
LCD Service Minder & Hour Meter (If so equipped)
When the ignition key is rotated
out of the STOP position but
not into the START position, the
LCD Service Minder and Hour
Meter will briefly display the
battery voltage, followed by the
tractor's accumulated hours.
NOTE: Hours of tractor operation
are recorded any time the ignition
key is rotated out of the STOP
position, regardless of whether
the engine is started.
The LCD Service Minder will remind the operator of maintenance
intervals for changing the engine oil, air filter service, low engine
and low battery warnings.
Change Oil
CRUISE
The LCD will display the letters "CHG", followed by the letters
CONTROL
"OIL", followed by the letters "SOON", then finally followed by the
meter's accumulated time. "CHG/OIL/SOON/TIME" will alternate
on the display for 7 minutes after the meter reaches 50 hours.
This oil service minder interval will occur every 50 hours. Before
the interval expires, change the engine oil as instructed in the
Maintenance section of the Engine Operator's Manual
Low Oil
The letters "LO" followed by the letters "OIL", then followed by
the meter's accumulated time will indicate the tractor is low on
oil. When an engine is not running and immediately after the
engine is started the oil pressure may be low. This can trigger the
"LO" "OIL" text. This is normal. If the low oil indication persists
stop the tractor immediately and check the engine oil level as
instructed in the Engine Operator's Manual.
NOTE: The "LOW OIL" function only works if the engine is
equipped with an oil pressure switch.
Low Battery
At startup, the battery voltage is briefly displayed then changes
to accumulated hours. The letters "LO" will display followed by
the letters "BATT" and then followed by the meter's accumulated
time. "LO/BATT/TIME" is displayed on the LCD when the voltage
drops below 11.5 volts. When this occurs, the battery is in need
of a charge or the engine's charging system is not generating
sufficient amperage. Charge the battery as instructed in the
Service section of this manual or have the charging system
checked by your local service dealer.
Air Filter Service
The letters "CLN" will display, followed by the letters "AIR",
followed by "FILT", then followed by the meter's accumulated
time. "CLN/AIR/FILT/TIME" will alternate on the display for 7
minutes after the meter reaches 25 hours. This air filter service
minder time interval will be every 25 hours. On intervals that are
common with oil service, the oil message will be displayed first
followed by the air filter message.
LCD Service Minder & Hour Meter w/ Bluetooth® (If so
equipped)
Connect your Bluetooth®
enabled LCD service minder
& hour meter to your
smartphone by downloading
the Cub Connect™ App for your
Bluetooth® capable Android or
iOS device.
works with
CUB CONNECT
S 4 — c & F
ection ontrolS eatureS
15