Controls & Features - Cub Cadet RZT S Serie Manual Del Operador

Controls & Features
Brake Pedal
Steering Wheel
Seat Adjustment Lever
Fuel Tank Cap
Transmission Bypass Valves
NOTE: References to LEFT, RIGHT, FRONT, and REAR indicate that
position on the tractor when facing forward while seated in the
operator's seat.
Deck Height Index
The deck height index consists of eight index notches
located on the front/right of the console. Each notch
corresponds to a 1⁄2" change in the deck height position
ranging from 1-1⁄2" at the lowest notch to 4" at the highest
notch.
Deck Lift Handle
The deck lift handle is located on the front/right of the
console, and is used to raise and lower the mower deck.
Pull the handle to the left out of the index notch and push
downward to lower the deck, or pull upward to raise the
deck. When the desired height is attained, move the lift
handle to the right until fully in the index notch.
Forward Drive Pedal
Reverse Drive Pedal
Parking Brake/Cruise Control Lever
Deck Lift Handle
Deck Height Index
Throttle/Choke Control
PTO Knob
LCD Service Minder & Hour Meter
Cup Holder
Ignition Switch
Module
Storage Tray
Transmission Bypass Valves
Cup Holder
The cup holder is located on the RH console to the right of the
operator's seat.
Storage Tray
The storage tray is located at the rear of the RH console.
Seat Adjustment Lever
The seat adjustment lever is located below the left side of the
seat. The lever allows for adjustment of the fore to aft position of
the operator's seat. Refer to the Assembly & Set-Up section for
instructions on adjusting the seat position.
4
13