Ikegami ISD-A21 Manual De Instrucciones página 13

(3)SENS UP
The electronic sensitivity up modes can be selected with the L and R buttons.
At all the positions but OFF, the automatic gain control function turns on itself.
The HYP-AGC mode can also be switched on.
① OFF (initial setting)
② S/N
The signal-to-noise ratio priority mode is used in shooting subjects that vary in
brightness and move slightly.
③ STD
The standard mode is used in shooting subjects in brightness-changing spots to
suppress both blurry images and rugged looks.
④ MOVE
The motion priority mode is used in shooting subjects that vary in brightness and
move greatly like on the street and in parking lots.
* Note: With the sensitivity multiplying factor at maximum, the motion-dependent
blurriness and ruggedness look the same in all the 3 modes.
* Note: In the S/N, STD or MOVE mode, the gain control levels LOW, MID and HIGH
cannot be selected.
(4)SLOW SHUTTER
The electronic sensitivity multiplying factor can be adjusted with the L and R buttons.
x2, x4, x8, x16, x32
The higher the factor, the higher the sensitivity, but motions at maximum factor look unnatural.
5-4-5. WHITE BALANCE
The white balance mode is selected. The manual white balance settings are made.
(1)The white balance modes can be switched with the L and R buttons.
① ATW (initial setting)
White balance is automatically followed up.
② ATW Ex
White balance is automatically followed up, but the color temperature range gets
higher than the ATW mode. Compared with the ATW mode, color fading may be
caused under usual light sources.
③ AWC
This is the so-called one-push automatic white balance control. Shoot a target white
subject and press the E button, and the white balance will be adjusted.
④ MANUAL
Select MANUAL, press the E button
and the screen at left appears
onscreen.
R GAIN is used to adjust the reddish
shades.
B GAIN is used to adjust the bluish
shades.
ＷＨＩＴＥ ＢＡＬＡＮＣＥ
→Ｒ ＧＡＩＮ
Ｂ ＧＡＩＮ
ＲＥＴ
E-11