Ikegami ISD-A21 Manual De Instrucciones página 6

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

① Lens mount (CS mount)
This is used to mount the lens on the camera. Many types of CS mountlens can be
attached.
② Flange focal distance adjuster
Used to readjust the flange focal distance (distance between lens mounting face and
imaging area), if the camera fails to come into focus with the lens' focus ring.
③ Focus lock screw
Used to lock the camera's flange focal distance after is has been readjusted.
④ Holder mounting screw holes
These holes are used to fix the camera on the camera holder. They are also applicable
to general tripods.
Note
To attach the camera on a tripod or a camera holder, be sure to use mounting
screws. (1/4" -20UNC) that are shorter than 5.5 mm.
⑤ Lens selector switch
The switch has two positions, for a video iris lens and a DC iris lens.
⑥ Auto iris lens connector
Specifically used to connect the auto iris lens.
• For the video type auto iris lens
Set the lens selector switch to VIDEO position.
— Connector cable leads —
1. Red (power)
2. Not used
3. White (video)
4. Black (shielded)
* Dress the tip of the green lead to prevent a short-circuit.
• For the DC type auto iris lens
Set the lens selector switch to DC position.
— Connector cable leads —
1. Damping coil (-)
2. Damping coil (+)
3. Driving coil (+)
4. Driving coil (-)
* Connect the leads as shown above.
Refer also to the instructions of the lens.
4
2
3
1
4
2
3
1
E-4
Auto iris lens
Auto iris lens

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido