Cleaning And Servicing; Troubleshooting - Bosch MMBM1 Serie Instrucciones De Uso

Blender_Mini_en-es-id-th-2zh.book Seite 7 Donnerstag, 17. Juli 2014 12:59 12
Insert blade holder into the jug and lock

by turning it anti-clockwise.
Turn over grinder attachment.

Attach grinder attachment to the drive

on the motor block. Mark on the jug points
to mark ( ) on the motor block.
Attach grinder attachment by turning

it all the way clockwise
Switch on the appliance. To do this, press

the switch on setting  and hold down.
Note: The longer the appliance remains
switched on, the finer the ingredients
are ground.
After using the appliance
Release switch.

Remove mains plug.

Remove the grinding attachment by

rotating it in an anti-clockwise direction.
Turn over grinder attachment.

Rotate the blade holder in a clockwise

direction and remove.
Empty jug or place lid on jug.

Clean all parts, see "Cleaning and

servicing".

Cleaning and servicing

The appliance requires no maintenance!
Thorough cleaning guarantees a long
service life.
m
Risk of electric shock!
Never immerse the motor block in water
and never hold under running water and
do not clean in the dishwasher.
m
Risk of injury from sharp blades!
Do not touch blade with bare hands.
Clean them with a brush.
Warning!
Do not use abrasive cleaning agents.
Surfaces may be damaged.
Tips:
– Preferably clean the parts immediately after
use. This will prevent residue from drying
on and attacking the plastic (e.g. by essen-
tial oils in herbs).
Robert Bosch Hausgeräte GmbH
– Pour a little water and washing-up liquid into
the attached blender.
Switch on for a few seconds.
Pour out the water and rinse the blender
with clean water.
– If processing e.g. carrots and red cabbage,
the plastic parts will become discoloured
( ) by a red film which can be removed with
.
a few drops of cooking oil.
Fig.
Cleaning the motor block



Cleaning the blender attachment
The blender jug, smoothie insert, lid and
measuring cup are dishwasher-safe.
Cleaning the grinder attachment
Do not clean blade holder in the dishwasher,
but under running water using a brush.
Do not leave in water!
Jug and lid are dishwasher-proof.

Troubleshooting

m
Before rectifying a fault, pull out the mains
plug.
Fault:
Appliance does not start or appliance
switches off during operation.
Possible cause:
Attachment has become detached.
Remedial action:



If the fault cannot be eliminated, please
contact customer service (see customer
service addresses at the end of this
booklet).

Remove mains plug.
Wipe motor block with a damp cloth.
If required, use a little detergent.
Then wipe dry.
Risk of injury!
Release switch.
Correctly attach the attachment and
screw on all the way.
Switch the appliance on again.
Important information
en
7