Installation; Tool Caddy Assembly; Wheels/Caster Assembly - Craftsman CMXEVBE176120 Manual De Instrucciones

INSTALLATION

Tool Caddy Assembly (Fig. C)
Locate the Tool Caddy and the Bag Assembly with four
screws in the carton. The Tool Caddy is designed to fit on
the back of the 4-Gallon (15 Liter) Drum.
NOTE: The Tool Caddy MUST BE assembled to the Vac
BEFORE fastening the Wheels.
1. Remove the Powerhead from the Drum and set
aside.
2. Turn the Drum upside down on a flat surface.
3. Turn the Tool Caddy upside down and align to the
back of the Drum.
4. Install the Four Screws in the allotted Holes using a
Phillips Screwdriver. Tighten Screws until snug.
Do not over tighten as this may tend to deform the
Caddy.
5. Replace and relatch the Powerhead Assembly onto
the Drum.
Fig. C
Pull Latches
Outward and Then
Lift Power Head Up
By The Handle
Drum
Tool Caddy
6
Handle
Power
Head
Latch (2)
Phillips
Head
Screw (4)

Wheels/Caster Assembly

NOTE: The Tool Caddy MUST BE assembled to the Vac
BEFORE fastening the Wheels.
Locate the Two Wheels and the Caster in the carton.
Caster Assembly (Fig. D):
1. Insert the Caster into the Bottom of the Drum,
as shown.
2. Push the Caster until the Flange on the Caster Stem
is inserted all the way into the Socket. You will hear
the Flange snap into the Socket. The Caster will swivel
easily when positioning is correct.
Fig. D
Caster (1)
Caster Flange
Socket
Drum
Bottom