Check Before Operation - Pentair Flotec HYDROBLASTER 2.5 V Manual Del Usuario

EN
CHAPTER 4

CHECK BEFORE OPERATION

1) CHECK
•
Look around and underneath the engine for signs of oil or gasoline leaks.
•
Look for signs of damage.
•
Check that all shields and covers are in place, and all nuts, bolts, and screws are tightened
2) CHECK OIL
CAUTION: When stopping the engine at horizontal place, check the oil
1) Take the oil dipstick and clean
2) Insert the oil dipstick in and check the oil lever without screwing down.
3) If the oil is too low, add the recommenced oil in.
4) After finishing, reassemble and screw the oil dipstick down
OIL DIPSTICK
The Oil Alert system (applicable engine types) will automatically stop the engine before the oil level falls below safe
limits. However, to avoid the inconvenience of an unexpected shutdown, always check the engine oil level before
startup.
3) CHECK FUEL
First stop the engine, open the fuel cover, and check oil level., if the oil level is too low, add the fuel to full, after
finishing, screw the fuel cover down.
Don't add the fuel over the shoulder of the carburetor when fueling (maximum oil level).
Fuel tank volume : 1.6 L
Recommended octane rating over 90 unleaded gasoline
6
Maximum fuel
oil level
UPPER OIL LEVEL
LOWER OIL LEVEL
ORIGINAL INSTRUCTIONS