Tabla de contenido
Publicidad
Janome MS5027 Instruction Manual
SECTION II. GETTING READY TO SEW
Connecting Machine to Power Supply
q Foot control plug
w Machine plug
e Power supply plug
r Power switch
t Power supply cord
y Foot control
Before connecting the power cord, make sure the voltage
and frequency shown on the machine conform to your
electrical power.
1. Turn off the power switch r.
2. Insert the foot control plug q, machine plug w into the
machine.
3. Insert the power supply plug e into the outlet.
4. Turn the power switch.
Before Using Your Sewing Machine
Before using your sewing machine for the first time, place a
waste fabric under the presser foot and run the machine
with thread for a few minutes. Wipe away any oil which may
appear.
For Your Safety
* While in operation, always keep your eyes on the sewing
area. Do not touch any moving parts such as the thread
take-up lever, handwheel or needle.
* Always turn off the power switch and unplug from the
power supply:
- When leaving the machine unattended.
- When attaching or removing any parts.
- When cleaning the machine.
* Do not place anything on the foot control, when not
sewing.
Polarized plug
This appliance has a polarized plug (one blade wider than
the other). To reduce the risk of electric shock, this plug is
intended to fit in a polarized outlet only one way. If the plug
does not fit in the outlet, reverse the plug. If it still does not
fit, contact a qualified electrician to install the proper outlet.
Do not modify the plug in any way.
Foot Controller Model 21316 or YC-485 is used with
Sewing Machine Model 385.16231.
Controlling Sewing Speed
Sewing speed is varied by the foot control.
The harder you press on the foot control, the faster the
machine runs.
www.toews.com
y
6
Janome Pink Ribbon
r
e
w
q
t
MS5027 Owners Manual/ User Guide
Publicidad
Tabla de contenido
