Start-Up And Every Day Use; General Information; Every Day Use; No Power Supply - Piusi E300 Instalación Uso Y Mantenimiento

Installation, use and maintenance
N

START-UP AND EVERY DAY USE

N1

GENERAL INFORMATION

FOREWORD
ATTENTION
N2

EVERY DAY USE

1
2
3
4
5
6
7
ATTENTION
N3

NO POWER SUPPLY

NOTE
O

NOISE LEVEL

Under normal operating conditions noise emission for all models does not exceed the value of 70 dB
"A" at a distance of 1 Meter from the electric pump.
50
/56
Make sure that the hoses and line accessories are in good condition. Oil
leaks can damage objects and injure persons.
Extreme operating conditions can raise the motor temperature and, consequently,
cause the thermal protection switch to stop it.
Switch off the unit and wait for it to cool down before using again. The thermal
protection automatically turns off when the motor is sufficiently cool.
Before starting up the system, make sure that the unit has been assem-
bled correctly, with all lids correctly closed.
Supply voltage to the system by connecting the plug to the mains
If flexible pipes are used, attach the ends of the piping to the tanks. In
the absence of an appropriate slot, solidly grasp the end of delivery pipe
before beginning dispensing.
Before starting the pump make sure that the delivery valve is closed (dis-
pensing nozzle or line valve).
Turn the ON/OFF switch on.
Open the delivery valve, solidly grasping the end of the tubing.
Close the delivery valve to stop dispensing.
When dispensing is finished, turn off the pump.
Operation with delivery closed is only allowed for short periods (2 to 3
minutes maximum). After use, make sure the pump is turned off.
An electric power failure, with the consequent accidental stopping of the
unit, can be caused by:
- safety device tripping (if present at the system inlet)
- drop in line voltage
- fuse burnt out
M0362 A ml