Chin Strap Installation; Shroud Attachment - 3M Whitecap W-8100B-CA Instrucciones De Uso

Height and Faceshield distance Adjustment
Remove the head suspension from the inner shell whenever you wish to change the height, balance
or faceshield distance of the helmet. these adjustments can be made simply by moving the four
adjustment buttons on the top of the headband into different holes in the crown strap. to begin,
disengage each of the 4 headband adjustment buttons from the holes in the crown strap.
To position the headband lower on your head:
Snap each of the 4 headband adjustment buttons into the top holes of the crown strap.
To position the headband higher on your head:
Snap each of the 4 headband adjustment buttons into the bottom holes of the crown strap.
To move the faceshield away from your face:
Snap each of the 4 headband adjustment buttons into the front holes of the crown strap.
To move the faceshield closer to your face:
Snap each of the 4 headband adjustment buttons into the back holes of the crown strap.
To tilt the headband so that the nape strap fits lower on the back of your neck:
Snap the back 2 headband adjustment buttons into the back holes of the crown strap.

Chin Strap Installation

1. Hold the helmet shell upside down in your lap.
2. fasten hooks on the ends of the chin strap through the small holes on each side of the inner shell.
Make sure the chin strap is not twisted (fig. 7).
3. Adjust the length of the chin strap for a comfortable fit.
fig. 7

Shroud Attachment

the inner and outer shrouds are secured to the outside of the helmet shell for easy attachment and
removal.
Inner Shroud
Stretch the elastic band over the bottom of the helmet and into the shroud groove. Line up the seam of
the shroud with the seam on the front of the helmet.
13