3M Whitecap W-8100B-CA Instrucciones De Uso página 15

Abrasive Blasting Screens
When using the optional abrasive blasting screen (W-8116) place the screen into the faceshield frame
first.
1. Move the swivel locks at each end of the frame to the center and the back (fig. 10).
2. Place the straight edge of the screen at the top of the frame against the gasket.
3. to protect the outer faceshield, 3M recommends that a single faceshield cover be used between the
screen and the outer faceshield.
Faceshield Covers
1. Move the swivel locks at each end of the faceshield frame to the center and the back (fig. 10).
2. Place one to five faceshield covers inside the faceshield frame with the perforated straight edge
facing the gasket. When the top cover becomes unserviceable, remove each one by pulling outward
and then across in one quick motion.
- there are two tabs perforated into the cover(s). Keep the small tab(s) on the inside of the frame
(fig. 11).
- Push the large tab(s) to the front side of the frame. bend each one separately for easy removal.
- to prolong the life of the outer faceshield, do not remove the last cover in the work area.
fig. 10
fig. 11
15