Enter The Contaminated Area; Exit The Contaminated Area; Inspection, Cleaning And Storage; Inspection - 3M Whitecap W-8100B-CA Instrucciones De Uso

Enter the Contaminated Area

before you enter a hazardous atmosphere wearing this respirator, you must inspect the respirator,
complete a user performance check, and don the respirator according to the instructions in the,
"operating Instructions" of these User Instructions and the User Instructions provided with the
components of the system you are using. Failure to do so may adversely affect respirator
performance and result in sickness or death.
do not wear this respirator system to enter areas where atmospheric concentrations of
contaminants are unknown, immediately dangerous to life or health, exceed the Maximum Use
Concentration (MUC) for the respirator headpiece, or where atmospheres contain less than 19.5%
oxygen. Failure to do so may result in sickness or death.
1. With the respirator in operation, enter the contaminated area, breathing normally.
2. Keep all respirator system components away from equipment, vehicles and other physical and
chemical hazards.

Exit the Contaminated Area

1. While still connected to the supplied air system, leave the contaminated area.
2. before reaching inside the respirator for any reason, clean your hands of any contaminants.
3. remove the respirator in a clean area.
4. disconnect the supplied air hose from air source.
5. Refer to the "Inspection, Cleaning and Storage" section of these User Instructions for cleaning,
inspection and storage information.

INSPECTION, CLEANING ANd STOrAGE

Inspection

the respirator should be inspected before and after each use for defects that could affect the
performance of the respirator. following the requirements outlined in oSHA 29 CfR 1910.134, the
maintenance and inspection program should assure that the user is provided with a respirator that is
clean, sanitary, and in good operating condition.
failure to conduct an inspection and complete all necessary repairs before use may adversely
affect respirator performance and result in sickness or death.
Shroud Inspection
Replace the outer shroud (W-8057) if it becomes worn or damaged or cannot be secured to the helmet.
Replace the inner shroud (W-8020 or W-8021) if it becomes worn or damaged or cannot be secured to
the helmet.
WArNING
WArNING
20