Stand Attachment For Control Unit; Secretion Jar Lid Attachment; Floor Pedal Connection; Infiltration Accessory Connection - Nouvag Vacuson 60 LP Instrucciones De Uso

4.2 Stand attachment for control unit

1) Slip washers on Phillips screws.
2) Insert screws in holes and screw into Control unit threaded holes.
3) Drive screws home gently with a Phillips screwdriver.

4.3 Secretion Jar Lid attachment

1) Place Jar in vertical position.
2) Insert lid with O-ring on Jar rim.
3) Clear Spring Clamp from outer rim, allowing lid to drop
in place.
4) Press Lid down firmly with handle.
5) Turn Spring Clamp into position.
6) Snap Spring Clamp down into holding position.
When using the VACUSON 60LP, the Secretion Jars must be in their
holders at all times! This is to avoid tipping and spillage which could
destroy the pump!
Please follow the separate Instructions for the use of the disposable Monokit bottles (not included).

4.4 Floor pedal connection

The VACUSON 60LP comes equipped with a Floor Pedal, which can be connected or disconnected
on the back panel of the Control Unit

4.5 Infiltration Accessory Connection

Switch off the device before connecting
the infiltration accessory!
1) Turn left and right adjusting screw on the pump head up to the right stop
position (8.0).
2) Lift lid to open
3) Insert tube for infiltration . ( Pay attention to flow rate
4) Put lid down to close.
No. 31793 15/11
Vacuson 60LP
direction)
5