Normal Operatingdisplay; Lamp Hours Display; Light Brightness Control; Standby - Sunoptic Surgical Titan x450 Manual De Usuario

6.2.2 NORMAL OPERATINGDISPLAY

6.2.2.1
Shows total lamp on hours.
6.2.2.2
The user may adjust the light brightness by touching the minus
controls on thenormal operating displaytouch screen.
NOTE
The brightness control operates a progressive electro-mechanical shutter. The
lamp is running at full power if the power switch is on no matter where the
brightness control is set.

6.2.2.3 STANDBY

Touching STANDBY
(not strobe) flashes the word "STANDBY" on/off in one second Intervals. Touching
STANDBY again while in STANDBY mode will restore the light to the preset brightness
value showing on the screen.
6.2.2.4
The MENUbutton gives the operator access to five functions of information and
control. Repeatedly touching the MENU button will cycle through the five MENU
functions, as follows:
LIT-219 SUNOPTIC SURGICAL
(English)
LAMP HOURS

LIGHT BRIGHTNESS CONTROL

dims the light by moving the shutter to fully occlude it and "softly"

MENU

®
or plus
Rev. -
Date of Revision: 06/21/16
Page 14 of 104