Blackstar Amplification CORE STEREO 10 V2 Manual Del Usuario página 10

This setting is saved when you store a patch.
8. REV (Reverb)
Press this switch to turn the stereo reverb effect on, off, or focus the effect for
editing. This setting is saved when you store a patch.
For all three effect switches/buttons, the LED shows what state the effect is in:
LED
LED not on
LED red
LED green
Repeatedly pressing each effect switches on the front panel has the following effect:
Current Effect State
Effect off
Effect on but not 'focused'
Effect on and 'focused'
NOTE: Only one effect may be 'focused' at any time.
9. Effect Type
This changes the effect type and edits a parameter of the currently 'focused' effect
(modulation, delay, or reverb).
Each segment represents a different effect (four for each type of effect). An
LED shows which effect type is currently active. The distance travelled through
the 'segment' modifies an effect parameter. The Effects Table below shows the
modifiable parameters.
This setting is saved when you store a patch.
10. Effect Level
This modifies an effect parameter. For modulation and delay effects, turning the Level
control while holding down the Tap button (11) modifies the rate/time of the effect.
The Effects Table below shows the modifiable parameters.
This setting is saved when you store a patch.
10
Effect State
Effect off
Effect on but not 'focused' for editing
Effect on and 'focused' for editing
Next Effect State
Turns the effect on and 'focuses' the effect. Any previously focused effect
reverts to an 'on' state
Focuses the effect. Any previously focused effect reverts to an 'on' state
Turns the effect off. If any other effect(s) are on, the previously 'focused' effect
resumes being 'focused'
Description
Effect not active
Effect is active, but not affected by the front
panel effect controls
Effect active and affected by the front panel
effect controls