Height Adjustment - Nuna pipa next Manual Del Usario

The load leg has 19 positions. When the load leg
indicator shows red this means the load leg is in
the wrong position.
Make sure the load leg is in full contact with the
vehicle floor pan.
To shorten the load leg, squeeze the load leg
release button and pull the load leg upwards.
(11)-1
The completely assembled base is shown as (12).
The ISOFIX connectors must be attached and
locked onto the ISOFIX anchor points. (12)-1
The load leg must be installed correctly with
green indicator. (12)-2
6
To remove the base, press the secondary lock
button (13)-1 first and then the button (13)-2 on
the latch connectors before removing the base
from the vehicle seat.
7
Press the ISOFIX adjust button to fold the ISOFIX.
8
Push the infant carrier module down into the base
(14), if the enhanced child restraint is secure, the
side impact shield will be open and the enhanced
child restraint indicator shows green. (15) The
side impact shield which is away from the door
can be closed as shown on (16) when do not use
it.
Pull up on the infant carrier module to be sure it is
securely latched into the base.
17
PIPA next instructions
9
To release the infant carrier module, pull the
enhanced child restraint up while squeezing the
infant carrier module release button. (17)

Height Adjustment

for Head Support and Shoulder Harnesses
Check that Shoulder Harness Straps are set at the
proper height. Please choose the proper pair of
shoulder harness slots according to the child's height.
Shoulder Harness Straps must be nearest to your
childs shoulders (18), but not above the shoulder
line. (19)
If the Shoulder Harness Straps are not at proper
height, the child might be ejected from the
enhanced child restraint if there is a crash.
Pull the head support adjustment lever (20),
meanwhile pull up or push down the head support
until it snaps into one of the 7 positions. The head
support positions are shown as (21).
18
PIPA next instructions