Securing Child; Installation Without Base - Nuna pipa next Manual Del Usario

Securing Child

Use Infant Insert
We recommend
using the full infant
insert while the baby
is under 60 cm or
until they outgrow
the insert. The infant
insert increases side
impact protection.
After the child is placed into the seat, check whether
the Shoulder Harness Straps are at proper height.
1
While pressing the harness adjustment button,
pull completely the two Shoulder Harness Straps
of the enhanced child restraint. (22)
2
Unlock the buckle of the harnesses by pressing
the red button. (23)
3
Place the child into the infant carrier module and
lock the buckle. (25) Please refer to (24).
4
Tighten the shoulder harness straps by pulling the
adjustment webbing. (26)
19
PIPA next instructions
Remove the infant insert
when the infant's
shoulders no longer fit
comfortably.
Make sure the space between the child and the
Shoulder Harness Straps is about the thickness of
one hand.
Canopy
1
Unzip the zipper of the front canopy bow. (27)
2
Pull the dream drape™ out of the canopy. (28)
3
Attach the magnets on each corner to the front of
the infant carrier module with magnets. (29)
4
The canopy window can be opened for
ventilation. (30)
Detach & Assemble Soft Goods
see images (31)-(42)
To re-assemble the soft goods, reverse the
aforementioned steps.

Installation without Base

1
DO NOT install this infant carrier module on
vehicle seats with Lap Belts. (43)
2
This infant carrier module is suitable for vehicle
seats with a 3-point Retractor Safety Belt
(without base) only. (44)
3
Place the infant carrier module onto the vehicle
seat where you wish to put it. Pull the vehicle
safety belt out and lock it into the vehicle buckle,
sliding the vehicle lap belt into the side guides of
the infant carrier module. (45)
20
PIPA next instructions