Error Messages - Silvercrest SBB 850 B2 Instrucciones De Uso

Taking out the bread
Always use pot holders or oven gloves when re-
moving the hot baking mould
mould tilted over a grill tray and shake it lightly
until the bread slides out of the baking mould
If you haven't already removed the kneading
blades :
If the bread does not slip off the kneading blades
carefully remove the kneading blades
supplied kneading blade remover
NOTE
Do not use any metal objects that could cause
scratches on the non-stick coating. Rinse the baking
mould with warm water directly after removing
the bread. This will help prevent the kneading
blades becoming stuck on the drive shafts.
■ Press the Start/Stop button
the programme at the very start of the baking
phase or set the ON/OFF switch (--/O)
the "O" position. You must set the ON/OFF
switch (--/O) back to the "--" position within
10 minutes so that the baking process can be
continued.
■ Open the appliance lid
baking mould . With floured hands, you can
remove the dough and then pull out the knead-
ing blades .
■ Replace the dough in the back baking mould
Replace the baking mould
appliance lid .
■ Put the power plug into the socket if necessary.
The baking program continues from where it
was stopped.
Allow the bread to cool for 15–30 minutes before
eating it.
Before cutting the bread, always check to ensure
that the kneading blades
from it.
SBB 850 B2
. Hold the baking
.
,
using the
.
briefly to pause
to
and remove the
.
and close the
have been removed

Error messages

■ If the display shows "HHH" after the pro-
gramme has been started, this indicates that
the temperature in the bread maker is still too
high. Stop the programme and set the ON/OFF
switch (--/O) to the "O" position. Open the
appliance lid and allow the machine to cool
down for 20 minutes before reusing it.
■ If a new programme cannot be started directly
after the bread maker has completed a baking
process, it means the appliance is still too hot.
In this case, the display panel reverts to the
default setting (programme 1). Open the ap-
pliance lid and allow the machine to cool
down for 20 minutes before reusing it.
NOTE
► Do not attempt to reuse the appliance until it
has cooled itself down. This functions only in
programme 12.
■ If "EE0", "EE1" or "LLL" appear on the display after
the programme has started, switch the bread
maker off and then on again by setting the
ON/OFF switch (--/O)
and then back to the "--" position. If the failure
display persists, contact Customer Service.
to the "O" position
GB │ MT │ 79 ■