Publicidad
SUGGESTED SPARE PARTS TYPE 400BT OVENS
V.
Following quantities for each oven:*
• One (1) kit of (6) heating elements No. 1257141 (240/480
volt models)
• One (1) kit of (6) heating elements No. 1257142 (380 volt
models)
*For quantities of ovens exceeding 10, we suggest providing approximately 20% more of the above quantities of spares as sufficient for day to day operation.
For overseas operation we suggest a minimum of 30% more for spares.
CONTROLLER PROGRAMMING INSTRUCTIONS
VI.
Unit is shipped with controller programmed for
single temperature (in degrees Fahrenheit)
operation. Up to 8 ramp/soak control programs are
able to be programmed.
Initial Setting:
From the initial setting menu; temperature, units, control
mode and ramp/soak operations can be accessed. To
access initial setting mode, press and hold the ENTER key
for at least 3 seconds. Parameters can then be cycled
through by pressing the INDEX (loop) key.
Select Input Sensor Type:
Access initial setting menu until PV line displays InPt, press
DOWN arrow until J is displayed, press ENTER to accept
setting. After changing input sensor type, you will be
returned to the main screen.
Select Temperature Unit:
Access initial setting mode and press INDEX key until PV
line displays tPUn. Press UP/DOWN arrows until desired
unit is selected. Press ENTER to accept change.
Control Mode:
From initial setting mode press INDEX to CtrL. Default
from factory is ON/OFF control mode. Ramp/Soak profiles
• One (1) kit of (6) heating elements No. 1257143 (415 volt
models)
• One (1) Controller, kit No. 1257110
• One Thermocouple, No. 4303300
• One High Limit Control, No. 4312000
can be accessed here as well.
heat/Cooling Mode:
Selects heating or cooling operation. Set to HEAT.
Alarm Settings:
Up to three alarms may be set for various conditions.
SALA:
System Alarm Setting. Selects which alarm output is used
if a system alarm occurs. The system alarm would be in
Input Error or Process Control Failure. This
feature can be disabled by turning this parameter to oFF.
CoSh:
Communications Write Function Feature. Allows parame-
ters to be changed via the RS-485 communications.
Setting to oFF prevents any changes from remote users.
The following set of functions deal with RS-485
communications and can be found in the controller
operating manual.
N5610400-13
Publicidad
