Mounting And Placement - Master audio KEY8 Manual Usuario

Master Audio
WARNING!!!!: In order to allow a bridge connection between cabinets, each one of
them has been provided with two Speakon connectors that allow the Input / Output
function indistinctly. Terminal pins +1/-1 must be always used, disregarding the +2/-2
which are not internally connected.

3. MOUNTING AND PLACEMENT

For a proper installation of the acoustic cabinets, it is strongly recommended to read
carefully the following advices.
3.1. Placement
Fig.7. Flying placement
It is advisable to locate the subwoofer units on the floor as they can take advantage
of the so-called "floor-effect", thus increasing the response in the low frequencies.
If possible, place the subwoofers under the same acoustic axis used for the satellites.
If the above option cannot be carried out, then they should be placed in an
intermediate point between the left and right channels.
3.2. Tripod use
The KEY8, KEY12 and KEY15 models
are equipped with a tripod socket (A) for
use with a standard 35mm tripod.
Do not use the tripod on non-flat floors
and be careful not to raise the cabinet too
high on the tripod, as it may become
unstable.
Fig.8. Full range cabinet with tripod
KEY Series (Passive). Version 1.0
The Full Range cabinets should be located in a high
position (between two or three meters), slightly inclined to
the audience. If the loudspeakers are located too low, the
listeners at the end of the room will not hear a good sound
quality.
Jan14 6