Testing Seat Clamp And Post Clamp Tightness - Huffy BMX Serie Manual Del Usaurio

Seat Installation - continued
G
Post Clamp .
6. The tightening torque of the Quick Release Lever should be tight enough so that the
seat does not move during normal operation.
Seat Bolt Mount (various models)
I
Some models have a Bolt ,
J K
Washer and Nut instead
of a Quick Release Lever.
• If needed, loosen the nut
enough to insert the Seat
E
Post .
• Point the seat forward and
insert Seat Post to the Mini-
B
mum Insertion marks .
• Tighten Nut securely so it
supports the rider without
moving.

Testing Seat Clamp and Post Clamp Tightness

To test the tightness of the seat clamp and the post clamp:
• Try to turn the seat side-to-side and to move the front of the seat up and down.
• If the seat moves in the Seat Clamp:
• Loosen the Seat Clamp Nut.
• Put the seat in the correct position and tighten the Seat Clamp tighter than before.
• Do this test again, until the seat does not move in the Seat Clamp.
• If the Seat Post moves in the Seat Tube Clamp:
• Loosen the Seat Clamp Lever.
• Put the Seat Post in the correct position and tighten the Seat Clamp Nut tighter than
before.
• If necessary, tighten or loosen Hand Nut so that Quick Release tightens securely.
• Do this test again, until the Seat Post does not move in the Seat Tube Clamp.
18
B
C
I
Installation du frein à disque - suite
• Faire pivoter les leviers de
A
freins dans une position
d'utilisation confortable et
serrer de façon sécuritaire.
E K
J
AVERTISSEMENT
fig C
potence/roue peut pivoter de 360° sans courber aucun câble et que le mécanisme gy-
roscopique fonctionne parfaitement.
: Vérifi er que le système gyroscopique guidon/
A
suite >>
15