Connect Hose And Water Supply To Pump - Generac G0065650 Manual Del Propietário

Set-up

CONNECT HOSE AND WATER SUPPLY TO PUMP

DO NOT run the pump without the water supply connected
and turned on. Damage to equipment resulting from failure to
follow this instruction will void warranty.
Remove and discard the shipping cap from the pump's water
inlet before attaching hose.
1. Run water through your garden hose for 30 seconds to clean
out any debris.
2. Before connecting garden hose to water inlet, inspect inlet
screen before installing (A) (Figure 11). The cone should face
outward. Clean screen if it contains debris or have it replaced
if damaged. DO NOT run power washer if inlet screen is
damaged.
IMPORTANT: DO NOT siphon standing water for the water supply.
Use ONLY cold water (less than 100°F). Water supply must be
adequate to handle greater than 3.8 gallons per minute and no less
than 30 psi.
Using a One Way Valve (vacuum breaker or check valve) at
pump inlet can cause pump or inlet connector damage.
• There MUST be at least ten feet of unrestricted garden hose
between the power washer inlet and any device, such as a
vacuum breaker or check valve.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
Figure 11 – Inspect Inlet Screen
A
3. Connect the garden hose (not to exceed 50 feet in length) to
the water inlet (Figure 12). Tighten by hand.
8
NOTE:
NOTE:
NOTE:
Figure 12 – Connect Garden Hose
WARNING
Vision Loss. Eye goggles are required to be worn
when using this machine. Failure to wear eye
goggles could result in permenant vision loss.
• Always wear safety goggles when using this equipment or in vicinity
of equipment in use.
• Before starting the power washer, be sure you are wearing adequate
safety goggles.
• NEVER substitute safety glasses for safety goggles.
4. Connect lance to spray gun (Figure 13). Tighten by hand.
Figure 13 – Attach Lance
5. Attach end of high pressure hose to base of spray gun (Figure
14).
Fluid Injection. This machine produces high-
pressure uid streams that can pierce skin.
Fluid injection will result in death or serious
injury.
DANGER
(000101)
000119
(000106)