Pump Oil Maintenance - Generac G0065650 Manual Del Propietário

Ocultar thumbs Ver también para G0065650:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Maintenance
3. Remove the nozzle from the end of nozzle extension.
4. Use a small paper clip to free any foreign material clogging or
restricting the nozzle (Figure 29).
5. Remove the lance from the spray gun.
Figure 29 – Free Foreign Material
6. Using a garden hose, remove additional debris by back
flushing water through the lance (Figure 30) for 30 to 60
seconds.
Figure 30 – Back Flush Lance
7. Reinstall the nozzle into the lance.
8. Reconnect the lance to the spray gun.
9. Make sure the garden hose is connected to the pump water
inlet. Check that the high pressure hose is connected to the
spray gun and pump. Turn on the water.
10. Start the engine following the instructions How to Start Your
Power Washer.
11. Test the power washer by operating it with each quick connect
nozzle.
16
18

PUMP OIL MAINTENANCE

Change pump oil every 50 hours of operation.
1. Clean area around oil drain plug (A) (Figure 31).
2. Remove oil drain plug. Drain oil completely.
3. Install oil drain plug. Do not over tighten.
4. Clean Area around oil dipstick (B).
5. Fill pump with SAE 30 non-detergent oil. Oil level must be
between the "L" and "H" mark on dipstick (Figure 32). DO NOT
OVERFILL.
6. Install oil dipstick until finger tight.
7. Clean up any spilled oil.
000109
Figure 31 – Drain Pump Oil
B
A
Figure 32 – Dipstick
Acceptable Oil
"H"
Level Range
"L"

Publicidad

Tabla de contenido
loading

Tabla de contenido