Start Up - Truper DES-1000 Manual Del Usuario

Turning ON
• Make a loop (A) in the end of a
through the fastener as shown in image (B).
• Connect the trimmer to the extension cable as shown in the figure.
• Stretch perfectly the extension cable to prevent obstacles.
• Connect the extension cable to a power outlet with the
voltage specified for the trimmer.
• As an additional safety measure, use a current break (not
included) if there are voltage peaks of 30 mA or less.
• To turn ON the trimmer press the switch lock (C) together
with the switch (D). The switch lock prevents accidental
startups.
• To turn it OFF, release the switch.
Operation
CAUTION
• Remember that you as the trimmer
operator are responsible of your own safety as well as
those close to the work area. Follow all safety standards
(pages 4 and 5) before operating the tool.
• Keep good footing with both feet firmly set onto the
ground.
• Hold the trimmer firmly in front of you. One hand shall
be positioned on the handle and the other, onto the
auxiliary handle so that the tool is aligned to your body
and pointing the cutting head 30° towards the ground and
away from your feet.
DANGER • Do not start or operate the trimmer in
any other position.
• Turn ON the trimmer and carry out cuts from left to right
and rotating the waist keeping the tool position.
• As the grass is trimmed, the cutting line wears out and
will finally be detached. to release more line out from the
spool, press the trimmer a little downwards so that the
ground presses the retention cap against the spool and will
release more line. The remaining line will be cut with the
guard blade. In that instant stop pushing the trimmer
against the ground to not waste line.
• To cut weeds or high grasses cut gradually. Do not try to
cut in one pass from its base. Residues may clog the
cutting head to make the user lose control on the trimmer.
Edger
• It is possible to use the trimmer to cut and define the
grass border following the edge of sidewalks and paths.
• Loosen the knob (E). Tighten the button opposite to the
knob and release the curved axis.
• Turn the curved axis 180° to make the cutting line
point downwards (F).
• Insert again the curved axis until the button clicks.
Tighten the knob. The trimmer is ready to be used
as edger.
8
ENGLISH

Start Up

brand grounded extension cable labeled "Outdoor Use" and secure
B
A
E
D
Waist
rotation
30°
C
Cutting
Movement
F