Installing Flat Panel Display; Adjusting Mount Extension - peerless-AV Touchboards PC930 Serie Instalación Y Ensamblaje

Attaching Display
Guide hook slots of tilt bracket (F) onto M5 x 10 mm screws (J) in swivel/pivot bracket (E) as shown in figure 6.1.
6
Thread two M5 x 10 mm screws (J) through tilt slot of tilt bracket (F) into swivel/pivot bracket (E) as shown in
figure 6.2. Do not fully tighten screws to allow for tilt adjustments. Tilt slot allows for incremental tilts of 5°.
Adjust tilt of display and fully tighten all four M5 x 10 mm screws (J) as shown in figure 6.3.
• Do not lift more weight than you can handle. Use additional man power or mechanical lifting equipment to safely
handle placement of the display.
fig. 6.1
F

Adjusting Mount Extension

While supporting the weight of the display, loosen
7
screws (L) on clamp plate (D) half a turn and
position display to the desired height.
Retighten clamp plate screws securely.
WARNING
• Clamp plate adjustment screws support weight of
display when fully tightened. Weight of the display
will need to be supported if clamp plate screws are
loosened.
J
HOOK
E
SLOTS
WARNING
TILT
SLOTS
F
J
fig. 6.2
CLAMP PLATE
SCREWS
10 of 35
fig. 6.3
E
D
L
ISSUED: 11-29-07 SHEET #: 202-9263-3 04-25-14
J