Cebora SYNSTAR 270 T SRS edition Manual De Instrucciones página 22

This current is maintained as long as the welding torch
trigger is held down; when the welding torch trigger is
released this current connects to the welding current,
which is maintained till the welding torch trigger is pres-
sed again.
When the torch trigger is pressed again, the welding cur-
rent will connect to the crater current and it will be main-
tained until the torch trigger is released.
To adjust start current, connection time and crater
current values, enter the main menu by pressing key F
MENU and use key PARAMETERS to enter the process
parameter in the menu.
Turn knob 2 to select the parameter, press it to enter the
adjustment screen and turn it to adjust the value.
Press the DEF key to restore factory settings.
D
Inductance.
0.0
Adjustment ranges from -9.9 to +9.9. Factory setting is
zero. If the figure is negative, the impedance drops and
the arc becomes stiffer, while if it increases, the arc is
softer.
Touch to select the function. To adjust the value, just turn
knob 2.
E
Arc correction.
0.0
To modify arc length, select it by touch. To adjust the va-
lue, just turn knob 2.
22
F
Menu.
MENU
Touch to select this function.
Select to enter the main menu.
Process
CHOOSING THE WELDING PROCESS,
MIG, TIG OR MMA.
After selecting the MIG
2 you can select the arc transfer type: MIG Pulse, MIG
Short, MIG SRS and MIG Manual.
To confirm the selection, press knob 2 or key
Material
SELECTING WIRE TYPE, DIAMETER AND
WELDING GAS.
To confirm the selection press knob 2 or key
Parameters SELECTING PROCESS PARAMETERS.
• Arc length correction.
Turn knob 2 to select the parameter and confirm the
selection by pressing the same knob.
Adjust the value by turning knob 2.
To confirm the selection, press knob 2 or key
Press the DEF key to restore factory settings.
welding process, with knob
.
.
.