Framing And Support; Typical Installations - Jacuzzi COMFORT PLUS Serie Manual De Instalación Y Operación

Framing and Support

The drain/overflow of the bath extends below the bottom of the bath. Note that this requires a cutout in the floor.
The floor structure beneath the bath must be able to support a total weight of bath, water, and bather. Refer to the table under total
weight for your model. The unit must be supported from the bottom of the bath and not from the bath rim or tile flange. If the subfloor is level
and a continuous surface, no other preparation is necessary. You can proceed to install the bath. If the subfloor is not level, you MUST level the
entire surface prior to installing the bath. The use of materials that shim or provide a level installation are allowed provided the method used will
insure a level bath that is supported from the bottom. Materials that may be used are a floor leveling compound, mortar, plaster or minimal
expansion structural foam having a density of a minimum of 5 lbs./cubic ft.; however the bath must remain level in order for it to drain properly
and all foam feet must make full contact with the leveling material. Both sides of a joint or splice of subfloor should be level to each other. When
attaching baths with flanges to stud wall, use shims to fill any gaps between the bath flange and studs.
The rim of the bath is not designed to support weight. If finish material is to overlap or contact the bath, the added weight must be fully self-
supporting.
The protective film liner inside the bath is used to prevent damage to the finish during installation. Before installation, remove
liner to inspect for any defects, reapply and do not remove until final cleanup.
Important: If a skirt is to be used, it must be installed at the time of unit installation – refer to skirt installation instructions. Install
optional trim parts when all installation has been completed.

TYPICAL INSTALLATIONS

MORTAR OR ADHESIVE
FLASHING
1" X 4" (NOT FOR SUPPORT)
FLUSH TO WALL
TYPICAL FLANGE MOUNTING DETAIL
STUD
CAULKING
FLANGE
SHIM IF
NECESSARY
TO FILL GAPS
BETWEEN
1/8" GAP
STUD
AND FLANGE
©
Jacuzzi Whirlpool Bath BP43000 2/05
MORTAR OR ADHESIVE
TILE
SEALANT
SEALANT
SUB-FLOOR
FLASHING
1" X 4" (NOT FOR SUPPORT)
SEMI-SUNKEN
TILE
CEMENT
BOARD
TILE
ADHESIVE
ATTACH WITH
SCREWS
PROVIDED
STUD
FLANGE
TILE
PLASTER
FILLER
FLANGE
NAIL
OR
SCREW
STUD
WALL
OPTIONAL TILE FLANGE KIT
STUD
CAULKING
FLANGE
SHIM IF
NECESSARY
TO FILL GAPS
1/8" GAP
BETWEEN
STUD
AND FLANGE
4
FINISHING
MATERIAL
MORTAR
CEMENT
BOARD
BATH RIM
SILICONE
SEALANT
1" X 4" (NOT FOR
SUPPORT)
TILE
CEMENT
BOARD
TILE
ADHESIVE
ATTACH WITH
SCREWS
PROVIDED
STUD
FLANGE
1"X 4"
(NOT FOR
SUPPORT)