Allmatic HELIOS KAIROS Manual De Instrucciones página 14

4
LEARNING
4.1 Learning transmi• er through the learning key of the control unit
HELIOS KAIROS control unit can be operated by all remotes B.RO 2/4WN, WALL 433 MHz and the CLARUS
series.
a b
a1 b1
Warning: keys func! ons are only valid with the DIP4 OFF (see 6.2.4)
4.2 Learning subsequent transmi• ers with a transmi• er already learned
Warning: Do not use this procedure if you have mul! ple units in opera! on, since the store opening
would aff ect all devices where the channel is stored. In this case, disconnect the power supply of the
1. Opening of memory: to open the memory from the transmi# er, refer to the instruc! ons enclosed to the
transmi# er. Once you open the control unit memory, it indicates this by turning on the red LED.
2. Press "a" or "a1" of the transmi# er. The control unit also automa! cally memorize the key "b" or "b1" and
the "c" key to the series CLARUS ("a" or "a1" like bu# on "open", "b" or "b1" how "close" bu# on and "c" as
a "stop" bu# on). The control unit signals the memoriza! on of the channel with two fl ashings if the channel
was not memorized, with one if the channel was already learned.
3. Once memorized the channel, the control unit goes back to normal modality of func! oning. If no signal is
transmi# ed by 20 seconds, the control unit automa! cally exits from the learning mode.
Warning: keys func! ons are only valid with the DIP4 OFF (see 6.2.4)
14/44
1. Press and release the learning key on the card; the red LED lights up.
2. Press "a" or "a1" of the transmi# er. The control unit also automa! cally
memorize the key "b" or "b1" and the "c" keys to the series CLARUS
("a" or "a1" like bu# on "open", "b" or "b1" how "close" bu# on and "c"
a
as a "stop" bu# on). The control unit signals the memoriza! on of the
c
channel with two fl ashings if the channel was not memorized, with
b
one if the channel was already learned.
3. Once memorized the channel, the control unit goes back to normal
modality of func! oning.
If no signal is transmi# ed by 20 seconds, the control unit automa! cally
exits from the learning mode.
control units which shall not be involved.
ITA ENG FRA ESP DEU POR
6-1621090 rev3 16/03/2016