Led Indicator - Allmatic HELIOS KAIROS Manual De Instrucciones

8.2 Temporary exclusion of the rain and light sensors
This mode is used to temporarily disable the light and rain sensors (the rain sensor can be temporarily disabled
only if DIP switch 3 ON):
1. Move the awning to the desired posi! on.
2. With the awning s! ll in mo! on press and hold for 5 seconds the stop key (CLARUS) or the key of opposite
movement with B.RO 2/4WN WALL or cabled inputs.
3. The control unit shows the disabling of the sensors with 1 fl ash per second of the yellow LED.
The rain sensor, if the DIP 3 ON is disabled for 2 hours, if DIP switch 3 OFF is never disabled.
The light sensor is disabled for a full cycle of light (night-day, day-night). To exit the disabling sensors, it's
suffi cient to provide an open or close command and the control unit will return to automa! c mode.
8.3 Winter mode
This mode allows you to inhibit all the automa! c movements of the control unit, which is useful during the
winter:
1. Awning must not be in movement, it can be stopped at any posi! on.
2. Press and hold the close bu% on for 5 seconds.
3. The yellow LED indicates the entry of the winter mode with a blink every 2 seconds.
4. Once the awning has reached the closure, it inhibit any automa! sm.
To exit the winter mode, it's suffi cient to provide an opening command and the control unit will return to the
automa! c mode.
Note: the func! on can be used only if a light sensor is already memorized and it is enabled.
8.4 "Clock" func! on
The clock func! on cannot be used with dead man modality (DIP 2 OFF) and with the light sensor enabled (DIP
5 ON).
This mode allows you to open and close the awning at specifi c ! mes using a ! mer, which maintains closed the
wired contact "open" for more than 4 minutes. The awning will remain open un! l the contact is closed.
An alarm will close the awning and once the alarm stops, the awning is ge& ng opened, regardless of the
posi! on of the DIP 1.

8.5 LED indicator

The control unit is equipped with 8 LEDs for indica! ng the status of the sensors, and handling opera! ons.
LED1 ON: light above the set threshold
LED2 ON: wind speed above the set threshold
LED3 ON: rain detected
LED 4 ON: snow detected (see 6.3)
LED5 ON: the control unit is using the internal memory
LED6 ON: clock func! on
LED7 ON: awning is closing
LED8 ON: awning is opening
6-1621090 rev3
LED1 LED2 LED3
ITA ENG
16/03/2016
LED4 LED5 LED6 LED7
FRA ESP DEU POR
LED8
19/44