Allmatic HELIOS KAIROS Manual De Instrucciones página 15

4.3 Parameter reset to factory defaults
This deletes all parameters (posi! on automa! c opening, alarms) without erasing all transmi* ers.
To restore the parameters to the factory default is suffi cient to do the following:
1. Close the awning.
2. Press and hold for almost 7 seconds the learning key un! l the red LED alarm / learning fl ashes rapidly.
3. Release the bu* on.
The red LED stops blinking. The restora! on has been performed.
4.4 Rese• ng the memory and reset to factory se• ngs
At any ! me it's possible to reset the factory se# ngs by rese# ng the card. This also leads to the cancella! on of
all the remote controls, sensors and automa! c opening posi! on.
To reset the board is suffi cient to do the following:
1. Remove power to the control unit.
2. Press and hold the learning key while the control unit is powered up. The three LEDs red, green and yellow
lights fl ash once and a& er that they stay on.
3. Hold down the key un! l the red LED turns off .
4. Release the key.
A& er this opera! on every remote control and any wireless sensor must be programmed again.
5
USING A TRANSMITTER
By closed awning, pressing the key "a" of opening, the awning will roll down. To stop the rolling down press the
reverse key "b" or the "c" STOP (only for series CLARUS). A subsequent pression of "b" will reverse the rolling
mo! on.
a a b c b b
Opening Stop Closing
Warning: keys func! ons are only valid with the DIP4 OFF (see 6.2.4)
ITA ENG FRA ESP DEU POR
6-1621090 rev3 16/03/2016 15/44