Troubleshooting - Allmatic HELIOS KAIROS Manual De Instrucciones

9

TROUBLESHOOTING

Problem
When power up the
control unit no LED come
up
Transmi# ers keys doesn't
work
Red LED con! nues
blinking
10
REMOVING A TRANSMITTER
10.1 Removing a transmi• ers from the control unit
a b
a1 b1
e
a b
a1 b1
e
Warning: Do not use this procedure if you have mul! ple units in opera! on, since the store opening
would aff ect all the devices where the channel is stored. In this case, disconnect the power supply of
GUARANTEE
In compliance with legisla! on, the manufacturer's guarantee is valid from the date stamped on the product and is restricted to the repair or free
replacement of the parts accepted by the manufacturer as being defec! ve due to poor quality materials or manufacturing defects. The guarantee
does not cover damage or defects caused by external agents, faulty maintenance, overloading, natural wear and tear, choice of incorrect product,
assembly errors, or any other cause not imputable to the manufacturer. Products that have been misused will not be guaranteed or repaired.
Printed specifi ca! ons are only indica! ve. The manufacturer does not accept any responsibility for range reduc! ons or malfunc! ons caused by
environmental interference. The manufacturer's responsibility for damage caused to persons resul! ng from accidents of any nature caused by our
defec! ve products, are only those responsibili! es that come under Italian law.
6-1621090 rev3
Possible causes
• Missing power supply
• Plug is not connected
• Power failure
• Transmi# er isn't learnt on the
control unit
• Transmi# er isn't compa! ble with
the control unit
• Low ba# ery on the transmi# er
• Radio module not present or
broken
• One or more sensors in allarm
• Broken or low power on sensor
• Sensor disconnec! on
REMOVING transmi• er series B.ro:
Press the hidden key "e" on the transmi# er; the red LED turns on. This
opera! on is equivalent to press the learning key, but without access to the
control unit.
Press at the same ! me for some seconds the hidden key and "a" key of the
radio transmi# er to erase ("e"+ "a"). The control unit signals the happened
erasing with 4 long blinks. A% er that the control unit goes back
to the normal modality of func! oning.
REMOVING transmi• er series CLARUS
To delete one channel or the whole transmi# er it is necessary to access to
the internal menu of the transmi# er.
To do this refer to the instruc! ons of the transmi# er in use.
the control units which shall not be involved
ITA ENG
16/03/2016
Solu! ons
• Wait un! l it comes back
• Insert the plug
• Check the connec! ons, see
• Follow the procedure on paragraph
• Check if transmi# er is a B.RO o
• Change the ba# ery
• Insert the radio module or change
• Check the 8 LEDs to understand
• Need a technical interven! on
• In case of disconnec! on (fast
FRA ESP DEU POR
paragraph 3
4.1
CLARUS series
it
which sensor is in alarm
blinking of red LED) and need to
move the awning, set to OFF DIPs
5,6,7,8
21/44