Cleaning The Filter; Changing The Filter; Ec Declaration Of Conformity - Tornado SWB 26/8 Manual Del Usaurio

5.6.1 Cleaning the filter

Clean the filter (Fig. 11/1) in the dust vacuum as
necessary using the shaking device (Fig. 11/4).
In the case of extreme accumulation of dirt, clean
the filter as follows:
1. Switch the machine off and remove the
debris container.
2. Loosen the wing bolts (Fig. 11/5). Pivot the
filter support frame (Fig. 11/ 3) down and
remove it.
3. Remove the filter from the filter support
frame.

5.6.2 Changing the filter

Check the filter (Fig. 11/1) every 250 operating
hours for signs of wear and change it as
necessary.
1. Switch the machine off and remove the
debris container.
2. Unscrew the wing bolts (Fig. 11/5). Pivot the
filter support frame (Fig. 11/3) down and
remove it.
5.6.3 Install the Lint filter
If the machine is mainly used on carpet, you
have to install the lint filter (7).
1. Switch the machine off and remove the
debris container.
2. Unscrew the wing bolts (Fig.11/5). Pivot the
filter support frame (3) down and remove it.
3. Mount the lint filter (7) between filter and the
filter support frame
4. Hook the filter support frame in the holder
(Fig.11/6), if necessary, and fix in place with
the wing bolts.
Noise emission value
The sound pressure level (LpA) (at the ear of the
operator) measured according to DIN IEC 60335-
2-72 under normal working conditions: 70 dB (A)
Measurement inaccuracy (KpA): 2 dB (A)
Tornado Industries declares that the products
Tornado SWB 26/8
to which this declaration relates, conform
to the relevant provisions of the
safety and health requirements stipulated
in EC Directive 2006/42/EC and is in
accordance with 2004/108/EC.
Beat the filter clean or use a vacuum cleaner.
Be careful not to damage the filter ribs!
4. Insert the correct side of filter in the filter
support frame. The sealing strip (Fig. 11/2)
must point towards the suction turbine!
5. Hook the filter support frame in the holder
(Fig. 11/6) and fix in place with the wing
bolts.
6. Reinstall the debris container
3. Remove the filter from the filter support
frame.
4. Insert the correct side of the new filter in the
filter support frame. The sealing strip (Fig.
11/2) must point towards the suction turbine!
5. Hook the filter support frame in the holder
(Fig. 11/6), if necessary, and fix in place with
the wing bolts.
6. Reinstall the debris container
5. Reinstall the debris container.
EC Declaration of Conformity (corresponds to
EC Directive 2006/42/EC)
Reference was made to the following standards
and/or norms and/or technical specifications to
ensure proper implementation of the safety and
health requirements in the EC Directive:
EN 60335-2-72
EN 55012
EN 61000-6-2
17