Instruction; Initial Battery Charge; Prior To Starting Up; Operation - Tornado SWB 26/8 Manual Del Usaurio

2.2 Instruction

Instructions to operators are required before
putting the machine into service.

2.3 Initial battery charge

Before starting the machine up for the
first time, the batteries to be used must
be fully charged, properly, by

2.4 Prior to starting up

Carry out the following checks before starting the
machine:
1. Check the charge status of the batteries.

2.5 Operation

Please read the Safety Information in
Chapter 1. Before switching the machine
on, ensure that the drive bar (Fig.
3/3) on the handle has not been actuated.
1. Switch the machine on using the (Fig. 3/1)
button: rotary brush drive, dust vacuum and
side brush drive are ready to operate.
2. Lower the side brush to its working position
using the lever (Fig. 3/4). When working
without the side brush: do not lower the side
brush and press the button (Fig. 3/2) for the
side brush once. The green control lamp
goes out.
3. Actuate the drive bar (Fig. 3/3) on the
handle: the machine starts to work.
Start work immediately after actuating
the drive bar, otherwise imprints could
be produced on the floor. Release the
drive bar when driving over thresholds.

2.6 Stopping the machine

When the drive bar is released, the rotary brush
drive, dust vacuum and side brush drive switch
off automatically.
Only technicians from your local, authorized
Tornado dealer are allowed to provide initial
instruction on how to use the machine.
implementing the initial battery charge
routine.
2. Check the levels of wear on the rotary brush
and side brush.
3. Check the fill level of the debris
container.
Fig.3
8