Maintenance Information; Particular Risks - Tornado SWB 26/8 Manual Del Usaurio

respective function! It is too late to do this
when the machine is actually in operation!

Always wear heavy duty, non-slip footwear
when working with the machine.

The machine may only be used on those
surfaces which have been approved by the
contractor or person appointed by him.

When using the machine, it is essential to
pay attention to third parties, especially
children.

Accelerate the machine immediately after
switching on the brush head drive, otherwise
imprints of the brush could be produced.

1.4 Maintenance information


Operating personnel must complete the
necessary daily and weekly maintenance
work. All other maintenance work must be
completed at your local Tornado authorized
service center.

The maintenance work and maintenance
intervals prescribed in the operating manual
must be adhered to.

Suitable tools must be used for cleaning and
maintenance work.

The machine must be inspected by a
recognized technical expert in respect of
operational safety, within the terms of the
applicable accident prevention laws, at
reasonable intervals (we recommend at least
once a year) and following modification or
repairs.

Spare parts must comply with the minimum
technical requirements stipulated by the
manufacturer! This is ensured by the use of
original spare parts.

1.5 Particular risks

Electronics

In the case of defects in the electrical
installation, switch the machine off
immediately and clear the fault.

Work on the electrical equipment may only
be carried out by electricians who have
received the necessary training

The machine's electrical equipment must be
inspected/checked at regular intervals.
Defects, such as loose connections and
cable damage, must be rectified immediately.

The machine is not suitable for clearing up
hazardous, inflammable or explosive fluids,
dust or substances.

It is forbidden to use the machine in
potentially explosive atmospheres.

The side brush must be raised in order to
transport the machine.

The machine has been conceived for use on
level surfaces with a maximum gradient of
2%.

The machine must be switched off prior to
cleaning or servicing it or to replacing parts.
The drive bar must be out of operation!

Always disconnect the battery plug before
starting any work on the electrical
installation.

When working in the area of the raised hood,
it must be hinged open fully to prevent it
being knocked shut or further open and down
unintentionally.

It is not permitted to clean the machine with a
pressure washer or steam blaster.

It is not permitted to use aggressive and
corrosive cleaning agents.

Allow the machine to dry after being cleaned,
e.g. over the weekend.

Only start the machine up when all the safety
equipment has been installed and brought to
its protecting position.
Batteries

It is possible that sparking will occur when
connecting the batteries.

Batteries may only be handled and changed
by properly skilled maintenance personnel.

The machine has been set up for operation
using maintenance-free batteries. If other
battery types are used, the machine must be
set up for use with them by an authorized
Tornado service center.

Never lay any metallic objects or tools on
batteries - risk of short circuit!
5