Closing The Enclosure - OHAUS 7000 Serie Guia Del Usuario

An example of connecting via RS-232 to external equipment is shown below. Make the connections as necessary.

2.6 Closing the Enclosure

After all work has been completed inside the terminal, the enclosure must be snapped shut properly to maintain its
environmental integrity.
To properly close the terminal, follow these steps:
1.
Position the front cover over the rear housing then gently press it down into place.
2.
Press down firmly in each of the four corners of the front cover in sequence until each corner clip snaps audibly snaps
into place.
3.
It is very important that each of the 4 corner clips have snapped into place. When pressing down on the cover during
installation, listen for the "click" sound of each clip engaging.
3. OPERATION
3.1 Overview of Display and Controls
LCD display
Scale Function
keys
Operational
keys
ON/OFF key
NOTES:
1. USE ONLY SHIELDED CABLE.
2. MAXIMUM CABLE LENGTH: 50 FEET (15 METERS).
3. WIRE SIZE: 18 AWG (.823 mm
24 AWG (0.205 mm
Sample COM1 Connections
2
) MAXIMUM
2
) MINIMUM.
Alpha-
numeric
keypad
Navigation
keys
Print/Enter
key
EN-5