Install The Header Bracket - Craftsman 139.53925DS Manual Del Propietário

i u i,inullnUlU lu, nu
INSTALLATION STEP 2
Install the Header Bracket
You can attach the header bracket either to the wall above
the garage door, or to the ceiling.. Folfow the instructions
which will work best for your particular requirements. Do
not install the header bracket over drywall. If installing
into masonry, use concrete anchors (not provided).
WALL HEADER BRACKET INSTALLATION
o Center the bracket on the vertical centedine with the
bottom edge of the bracket on the horizontal line as
shown (with the arrow pointing toward the ceiling).
- Mark the vertical set of bracket holes.. Drill 3/16" pilot
holes and fasten the bracket securely to a structural
support with the hardware provided.,
HARDWARE SHOWN ACTUAL SIZE
........... ..... iLIlri l i,)
Lag Screw
5/16"-9×1-5/8"
Wall Mounting Holes
The nail hole is for
positioning only,
You must usa lag screws
to mount 1he header bracket
Wall Mounting Holes
Header/_/
-
Struclural _/[lt( Bracket.,..
tttk }! .,.
m. ""
Highest Point of /
Garage Door TraveI """_" I
/ _ VazttcaI
/ _LCenterlina of
/ t Garage Doer
. t \ Lag Screws
_I. _ I _It6"._,:1-s,_"
I_P_..--Verlical
i I
Centadine of
Garage Door
CEILING HEADER BRACKET INSTALLATION
= Extend the vertical centerline onto the ceiling as shown,
° Center the bracket on the vertical mark, no more than 6"
(15 cm) from the wall. Make sure the arrow is pointing
toward the wall..The bracket can be mounted flush
against the ceiling when clearance is minimal..
• Mark the side holes.. Drill 3/16" pilot holes and fasten
bracket securely to a structural support with the
hardware provided..
Ceiling Mounting Hotes
up
positlontngonty.. _ I '--J u _._i 1
You mosl use lag screws _'.. (_
to mount the header bracket,,
Door
. _ - - Finished Ceiling -
-" "_ _--" Header Centorline
Bracket o! Garage Door
6" (15cm)
Maximum
Header Wall
Garage Door
i Centedine
of Garage Door
13