Using The Wall-Mounted Door Control; To Open The Door Manually; Disconnect The Trolley - Craftsman 139.53925DS Manual Del Propietário

Using the Wall-Mounted
Door Control
THE PREMIUMCONTROLCONSOLE
Press the lighted push button to open or
close the door,. Press again to reverse
the door during the closing cycle or to
stop the door while it's opening
Light
feature
Lighted
Pus_ Button
ght
_ Button
H-Loc_
_,J Bulton
Press the Light button to turn the opener light on or off It
will not control the opener lights when the door is in
motion., If you turn it on and then activate the opener, the
light will remain on for 4-1/2 minutes.. Press again to turn it
off sooner. The 4-1/2 minute interval can be changed to
1-1/2, 2-1/2, or 3-1/2 minutes as follows: Press and hold
the Lock button until the light blinks (about 10 seconds). A
single blink indicates that the timer is reset to 1-1/2
minutes., Repeat the procedure and the light will blink
twice, resetting the timer to 2-1/2 minutes.. Repeat again
for a 3-1/2 minute interval, etc,, up to a maximum of four
blinks and 4-1/2 minutes.
Lock feature
Designed to prevent operation of the door from
hand-held remote controls., However, the door will open
and close from the Door Control, the Outdoor Key Switch
and the Keyless Entry Accessories..
To activate, press and hold the Lock button for 2 seconds.
The push button light will flash as tong as the Lock feature
is on..
To turn off, press and hold the Lock button again for
2 seconds° The push button light will stop flashing, The
Lock feature will also turn off whenever the "learn" button
on the motor unit panel is activated,
Additional
feature when used with the 3-Function
hand-held
remote
To control the opener lights:
tn addition to operating the door, you may
program the remote to operate the lights,,
1.,With the door closed, press and hold a
small remote button that you want to control the light,.
2..Press and hold the Light button on the door control..
3..While holding the Light button, press and hold the Lock
button on the door control,.
4,,After the opener lights flash, release all buttons,
To Open the Door Manually
To preventpossible SERIOUS INJURYor DEATH from a failing
garagedoor:
• If possible, useemergencyreleasehandleto disengage
trolley ONLYwhen garagedoor is CLOSEDWeakor broken
springs or unbalanceddoor could result in an open door
falling rapidly and/or unexpectedly,
• NEVER useemergencyreleasehandle unlessgarage
doorway is ctear of personsand obstructions,.
• NEVER use handleto pull door open or closed,tf rope knot
becomesuntied, you couldfall
DISCONNECT THE TROLLEY:
The door should be fuliy
closed if possible.. Pull down
on the emergency release
handle (so that the trolley
release arm snaps into a
vertical position) and lift the
door manually,
The lockout feature prevents
the trolley from reconnecting
automatically, and the door
can be raised and lowered
manually as often as
necessary..
i Tr°lley
isconnect Position
Lockout position
(Manual disconnect)
TO RE-CONNECTTHE TROLLEY:
Pull the emergency release
handle toward the opener at
an angle so that the trolley
release arm is horizontal., The
trolley will reconnect on the
next UP or DOWN operation,
either manually or by using
the door control or remote.,
.............. _Trolley
Trolley
'ooso
Emergency _
Release Handle
(Pull at 45_ angle)
To reconnect
3!