Control Console; To Add, Reprogram Or Change A Keyless Entry Pin - Craftsman 139.53925DS Manual Del Propietário

To Add, Reprogram or Change a Keyless Entry PIN
NOTE: Your new Keyless Entry must be programmed to operate your garage door opener.
USING THE "LEARN" BUTTON USING THE PREMIUM CONTROL CONSOLE
1,.Press and release the "learn" button
on motor unit..The learn indicator light
will glow steadily for 30 seconds°
2,.Within 30 seconds, enter a four digit
personal identification number (PIN) of
your choice on the keypad.. Then
press and hotd the ENTER button..
3. Release the button when the motor
unit lights blink.. It has learned the
code.. If light bulbs are not installed,
two clicks will be heard.
To change an existing, known PIN
tf the existing PIN is known, it may be changed by one
person without using a ladder
1..Press the four buttons for the present PIN, then press and
hold the # button.
The opener light will blink twice. Release the # button.
2.. Press the new 4-digit PIN you have chosen, then
press Enter,.
The motor unit lights will blink once when the PIN has been
learned.
Test by pressing the new PIN, then press Enter,. The door
should move..
To set a temporary PIN
You may authorize access by visitors or service people with a
temporary 4-digit PIN. After a programmed number of hours
or number of accesses, this temporary PIN expires and will
no longer open the door. It can be used to close the door
even after it has expired° To set a temporary PIN:
1. Press the four buttons for your personal entry PIN (not the
last temporary PIN), then press and hold the _: button,
The opener light will blink three times. Release the button,.
2.. Press the temporary 4-digit PIN you have chosen, then
press Enter.,
The opener light will blink four times_
NOTE: This method requires two people if the Keyless
Entry is already mounted outside the garage_
1..Enter a four digit personal
identification number (PIN) of your
choice on the keypad.1Then press
and hold ENTER_
2. While holding the ENTER button,
press and hold the LIGHT button on
the Premium Control Console.
,
Continue holding the ENTER and
LIGHT buttons while you press the
push bar on the Premium Contro_
Console (all three buttons are held).
.,
Release buttons when the motor
unit lights blink. It has learned the
code_If light bulbs are not installed,
two clicks will be heard.
..,I /
3oTo set the number of hours this temporary PIN will work,
press the number of hours (up to 255), then press 8:,.
OR
3..To set the number of times this temporary PIN will work,
press the number of times (up to 255), then press #.1
The opener light will blink once when the temporary PIN has
been learned_
Test by pressing the four buttons for the temporary PIN, then
press Enter., The door should move. If the temporary PIN was
set to a certain number of openings, remember that the test
has used up one opening.To clear the temporary password,
repeat steps 1-3, setting the number of hours or times to 0 in
step 3.
One Button Close: Opener can be closed by pressing
only the ENTER button if the one button close feature has
been activated. This feature has been activated at the
factory'.. To activate or deactivate this feature press and
hold buttons 1 and 9 for 10 seconds. The keypad will blink
twice when the one button close is active. The keypad will
blink four times when one button close is deactivated..
36