Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
10. Remote Control Operation.
button - Tap once to turn LIGHT ON or OFF.
Liquid crystal display shows the amount of
brightness as a percentage. Holding the button
down for more than 2 seconds will cycle light
through brightness settings. When turning the light
back ON, light will return to the same brightness
setting it was on when light was last turned OFF.
button - cycles through 3 FAN SPEEDS and then
returns to the OFF setting.
11. Testing Your Fan.
It is recommended that you test fan before
finalizing installation. Restore power from
circuit box and light switch (if applicable). Test
fan speeds with the
control. Test the light ON/OFF function with
the
button on the remote control. Test
dimmer function by holding down the
button for more than 2 seconds. (For more
detailed information on using remote control,
see Section 10 above.)
If the remote control operates all of the
functions of the fan and light, battery has been
installed correctly. If fan and/or light do (does)
not function, please refer to "Troubleshooting"
section to solve any issues before contacting
Customer Service.
Turn fan completely off before moving the
reverse switch (located on top of motor
housing.) Set reverse switch to recirculate air
depending on the season:
- LEFT position in summer (diagram 1)
- RIGHT position in winter (diagram 2)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower your
thermostat setting in winter without feeling a
difference in your comfort.
Important: Reverse switch must be set either
completely to the LEFT or completely to the
RIGHT for fan to function. If the reverse switch
is set in the middle position (diagram 3), fan
will not operate.
button on the remote
page 10
light dimmer setting
light button
fan button
diagram 1
diagram 2
fan setting
motor
housing
reverse switch
diagram 3
Publicidad
Capítulos
Tabla de contenido
