Canopy Assembly; Light Kit Assembly; Important - Craftmade Ellington E-TIT52ABZ5LKRCI Guia De Instalacion

7. Canopy Assembly.

Raise canopy to hanging bracket and align
slotted holes in canopy with loosened screws in
hanging bracket. Twist canopy to lock. Re-insert
screws (with washers) that were previously
removed (page 3, Section 4) and secure all
screws with Phillips screwdriver.
*Remember that antenna for remote control
receiver must rest outside of hanging bracket.

8. Light Kit Assembly.

Install one 100 watt max. halogen bulb, type
JD E11 (included).
Tip: Do not touch glass portion of bulb with fingers
or hands. Oil from skin can cause bulb to overheat
and go out prematurely. Use cardboard box or
foam wrapping bulb was packed with to layer
around glass portion of bulb.
Locate slots on glass shade and align with
nodules on fitter plate (located on underside of
motor housing). Gently push up on glass shade
and turn to the RIGHT (clockwise)
completely into place.
IMPORTANT: The glass shade must be removed
in order to replace the bulb. When you need to
replace the bulb, please allow bulb and glass
shade to cool down before touching. Keep in
mind not to touch the bulb itself as described
above (see "Tip" above).
until it slides
page 8
antenna
slotted
hole
bulb
glass shade
hanging bracket
canopy
nodule
fitter plate